Polycom OTX 300 Preparing To Install page 20

Preparing Your Room for the Polycom Open Telepresence Experience (OTX) 300 Installation
Power Outlets
(continued)
Camera Bracket
Obstructions
Side Wall Requirements
Color
Rear Wall Requirements
Color
Obstructions
Floor Requirements
Material and
Color
Floor Support
Levelness
Obstructions
General Room Requirements
Windows
Doors
Chairs
Noise
Vibration
Power and
Cooling
India
Italy
Australia, New Zealand
Are mounting holes drilled according to wall and placement plan on
page 30?
Are all devices, such as thermostats, removed from front wall?
Are side walls painted one of recommended colors?
If OTX Complete Experience Kit is being installed, is rear wall of
room painted white?
If OTX Complete Experience Kit is not being installed, is rear wall of
room painted one of recommended colors?
Are all devices, such as thermostats, removed from rear wall?
Is floor carpeted?
Is carpeting black?
Can floor accommodate weight of OTX components?
Is maximum deflection for levelness approximately 1" (2.54 cm)
across 20 ft (6.1 m)?
Is floor clear of any obstructing architectural elements?
Are windows removed and/or covered?
If door was located on front wall or rear wall of room, has it been
moved to side wall?
Are Herman Miller (or comparable) chairs ordered?
Is NC rating less than 30 NC/40 dBA?
Is HVAC at least 4 ft (1.2 m) away from Ceiling Microphone Arrays?
Is room free from excessive room or wall vibrations?
Is OTX camera bracket mounted to a stable load-bearing wall?
Are power and cooling below maximum of 2500 watts, 8530
BTUs/hour, and .71 cooling tons?
Check if Yes
Check if Yes
Check if Yes
Check if Yes
Page 20 of 32