Obstructions; Floor Requirements; Material And Color - Polycom OTX 300 Preparing To Install

Preparing Your Room for the Polycom Open Telepresence Experience (OTX) 300 Installation
If you are not planning to install the OTX Complete Experience Kit:
• Recommended Option: Paint the rear wall, including the baseboards, Benjamin Moore
November Skies eggshell finish 2128-50.
• Second Option: Paint the rear wall, including the baseboards, Behr Pewter Mug interior satin
enamel 770E-3.
• Third Option: Paint the rear wall, including the baseboards, with an equivalent to one of these
two colors from another manufacturer.

Obstructions

The rear wall of the OTX Complete Experience Kit is often installed close to the rear wall of the room.
As a result, you may find it difficult to reach or see any thermostats, fire strobes, fire alarms, light
switches, or other devices located on the rear wall of the room. Therefore, if any of these devices are
present on the rear wall of the room, you should move them to a side wall. Fire strobes and alarms
should never be blocked from view by the OTX 300.

Floor Requirements

Material and Color

• To obtain the best acoustics, use a room in which the floor is carpeted or have carpeting installed
in the room.
• Polycom recommends that you install a black carpet made of tiles similar to the following:
InterfaceFLOR™ Tectonics/Binary (Style Number 14137/Color Number 100060). Install the
floor with the lines aligned and as closely matched as possible; do not quarter-turn the tiles.
For more information, see http://www.interfaceflor.com/.
Page 13 of 32