Table of Contents
Advertisement
Safety instructions
h. Use clamps or a vice to hold work. It's safer than using your hand and it
frees both hands to operate tool.
4) Power tool use and care
a. Do not force the power tool. Use the correct power tool for your
application. The correct power tool will do the job better and safer at the
rate for which it was designed.
b. Do not use the power tool if the switch does not turn it on and off. Any
power tool that cannot be controlled with the switch is dangerous and
must be repaired.
c. Disconnect the plug from the power source before making any
adjustments, changing accessories, or storing power tools. Such preventive
safety measures reduce the risk of starting the power tool accidentally.
d. Store idle power tools out of the reach of children and do not allow
persons unfamiliar with the power tool or these instructions to operate
the power tool. Power tools are dangerous in the hands of untrained
users.
e. Maintain power tools. Check for misalign ment or binding of moving parts,
breakage of parts and any other condition that may affect the po wer
tools operation.
If dama ged, have the po wer tool repaired before use. Many acci dents are
caused by poorly maintained power tools.
f. Keep cutting tools sharp and clean. Properly maintained cutting tools with
sharp cutting edges are less likely to bind and are easier to control.
g. Use the power tool, accessories and tool bits etc., in accordance with these
instructions and in the manner intended for the particular type of power
tool, taking into account the working conditions and the work to be
performed. Use of the power tool for operations different from intended
could result in hazardous situation.
h. Damaged switches must be replaced at a cus to mer service repair centre.
Do not use power tools that cannot be switched on and off.
i. Do not leave power tools unattended while they are switched on. Always
switch off the tool and wait until it has come to a full standstill before
leaving.
j. If the mains cable has been damaged, it must be replaced with a special
mains cable. These can be obtained from the manufacturer or the
manufacturer's custo mer service department. The mains cable may only be
replaced by the manufacturer, the manufacturer's customer service
department or equally qualified persons.
UK Helpline 0905-1460005 • Ireland Helpline 1520-932626
Web Support: www.servotool.eu
Model Number: POT-250
OTM6008 Ma-GB-IRE 1006-15.indd 8
8
6/15/10 4:04:43 PM
Advertisement
Table of Contents
