Table of Contents
Advertisement
Assembly and operation
Accessories
Fig. 1
4 + 5. Sanding sole:
Sanding near edges, corners and hard to reach areas. (Depending on the
sanding paper for sanding of wood, paint, varnish and stone.)
6. Scraper:
Scraping on solid underground. For instance removal of glue, carpets and
tiles. (carpet, flooring)
7. E-cut sawblade:
Separating and deep plunge cuts, for sawing close to edges, in corners and
hard to reach areas. (wooden materials, soft materials)
8. Segmented HSS saw blade:
Separating and deep plunge cuts, for sawing close to edges, in corners and
hard to reach areas. (Hard and soft wood, plastic, non-ferrous metals.)
Mounting accessories
For saw blades, scrapers and disc cutters and cutting discs use the clamping
screw in combination with the retaining ring.
• Remove the clamping screw using an Allen key.
• Replace the tool and tighten it using the clamping screw. Check that the
tool is secure in the chuck and that the machine is correctly secured and
supported.
Fitting/replacing sandpaper
Using hook and loop fastening system.
•
Place the sandpaper in the middle of the sanding disc and press it firmly
with your hand.
•
Press the sandpaper firmly onto the plate with brief, firm pressure and
then switch on the machine. This ensures that the disc is correctly secured
and prevents excessive wear.
•
If the sandpaper is worn in a particular spot, you can remove it, turn it
120° and refit it or replace it.
Mounting the dust adapter.
Fig. 2
Mount the dustadapter using the 3 hexagonal screws as shown on figure 2.
Warning! Switch the machine off and unplug the machine before mounting
the accessories.
UK Helpline 0905-1460005 • Ireland Helpline 1520-932626
Web Support: www.servotool.eu
Model Number: POT-250
OTM6008 Ma-GB-IRE 1006-15.indd 12
12
6/15/10 4:04:44 PM
Advertisement
Table of Contents
