Boom Components; Boom; How To Replace The Boom Wear Pads; How To Use The Quick Attachment - Genie GTH-636 Service And Repair Manual

April 2018
1-1

Boom

How to Replace the Boom Wear
How to R eplac e the Boom W ear Pads
Pads
1 Lower wear pads: Using a lifting strap from
an overhead crane or a fork lift of sufficient
capacity, lift the boom tube just enough to
remove the weight from the pads.
2 Remove the wear pad retainer plates and
remove the wear pads from the boom.
3 Lubricate the wear surface of the new pads.
Refer to Maintenance Procedure, Lubricate
the Boom.
Note: Do not lubricate the side wear pads.
4 Install the wear pads. Install and securely
tighten the retainer plates. Do not over tighten.
Part No. 1287209GT

Boom Components

How to Us e the Quic k Attac hment

How to Use the Quick Attachment

1 Remove the quick attach lock pin. Tilt the forks
forward to pivot the quick attach connector
back.
1 Quick attach pin
2 Quick attach lock pin
3 Quick attach lock lever
4 Quick attach connector
5 Attachment hooks
2 Position the boom so that the quick attach pin
on the boom is below and centered between
the hooks on the attachment. Raise the boom
until the pin is secured n the hooks on the
attachment.
GTH-636
Service and Repair Manual
13