Table of Contents
Advertisement
Installing into boiler:
1.
Check that the burner is undamaged.
2.
Fit the burner and tighten it firmly using the two wing nuts supplied.
3.
Ensure that the burner is in a horizontal position and all connections are tight.
4.
Fit the cover and the plug.
5.
Wire up the overheating safety fuse following the electrical wiring diagram.
Outer auger:
6.
Install the auger through the opening over the burner.
7.
Ensure that the pipe slopes enough to allow the pellets to fall into the burner.
When using for the first time:
8.
Make sure there are enough pellets by the entrance to the outer auger.
9.
Force-start the auger by holding down the UP button by the power input point.
10.
If the pellets fall into the combustion chamber, turn off again by pressing DOWN.
Then restart the burner using electrical ignition.
Turning off the alarm:
11.
If the alarm goes off or the burner will not start, Press down button to reset alarm
Manual
NBE pellet system
BOILER INSTALLATION GUIDE
Hide quick links:
Advertisement
Table of Contents
