Table of Contents
Advertisement
IN
POWER
AUGER
BLOWER
INT. AUGER
IGNIGTION
EKSTRA 1
EKSTRA 2
BUS
V+, TX, RX, V-
PULS
EKST
PC
GND, RX, TX
Boiler Temp.
Smoke Temp.
Boiler return Temp.
Hot water Temp.
Out side Temp.
Watt / m2 sensor.
Burner Temp.
Photo Sensor
TEKST IN DISPLAY
WAIT
IGNITION 1
IGNITION 2
POWER
HOT WATER
PAUSE
COLD BOILER
STOP
SUMMER STOP
SUN STOP
HOT BURNER
PLUG DISCONNECTED
FAULT IGNITION
OFF
FAULT BOILER TEMP.
FAULT PHOTO SENSOR
FAULT BURNER TEMP.
FAULT OUTPUT
NO LIGHT
FORCE RUNNING AUGER Force running auger.
CLEANING
WOOD FIRING
COMPRESSOR CLEANING The burner is using compressor cleaning
Manual
NBE Pellets Systems
ELECTRICAL WIRING DIAGRAMS
OUT
PE-N-L
Power to controlbox
PE-N-L1 External auger
PE-N-L2
PE-N-L3 Internal auger
PE-N-L4
PE-N-L5 Pump, hotwater valve , compressor cleaning
PE-N-L6 Pump, hotwater valve , compressor cleaning
Intelligent motor print
A-B
Water flowmeter
A-B
External power off / on
Computer interface
T1 - T
T2 - T
T3 - T
T4 - T
T5 - T
T6 - T
T7 - T
Motor print
T8 - T
Motor print
Updating temperature sensor
First ignition.
Second ignition.
Regular mode.
Hot Water mode
Pause firing.
Boiler temperature has been to low and.
Pellets burner has stopped and waiting for the temperature to drop.
Out temperature is high and the burner has stopped.
Watt / m2 is to high and the burner has stopped.
The burner has been to high and is in an alarm..
Plug on the burner is disconnected.
The burner couldn't ignite and got in to an alarm.
The burner is turned off.
The boiler temperature sensor is out of range.
The photo sensor is out of range.
The burner temperature sensor is out of range.
An relay is broken.
Flashing when light sensor can see light, after 5 minutes it is an alarm
The burner is cleaning, with more fan speed.
O2 % has been 2% under the allowed level for more than X minutes
Hide quick links:
Advertisement
Table of Contents
