Installation Guide For Opop Boiler; General Guidelines; Installing The Burner Into The Boiler; Example Of Installation - Opop H 418 Manual

Wood pellets burner

Hide thumbs Also See for H 418:

Operating (31 pages)

Table Of Contents

Table of Contents

General guidelines:

The boiler should be installed by an authorized fitter and must

be installed in accordance with work supervision publication 42 ( Danish ) covering equipment working with

water. The outlet duct should be no longer than 1m, and should be fitted with a cleaning door.

The chimney draught should be at least 5 PA and should be stable, a draught stabilizer should always be

installed. If combustion gases condense in the chimney (wet ash) install a draught stabilizer in the chimney,

or open the flue (the flap inside at the back of the boiler) as wide as possible to increase the temperature

of the smoke. The boiler must be spanned with a bypass to ensure the back flow is always kept above

45 degrees.

Installing the burner into the boiler:

Install the burner on the side of the boiler

(there should be no shield on the burner, when using the comfort boiler ).

Fit the controls either on the cabinet or on the wall.

Install the overheating safety cut off into the pocket on the side of the boiler, and connect the

controls so that the overheating safety cut off will cut the power if the boiler overheats.

Install the heat sensor on the output flow, either in the pocket or by the sensor on the output

flow. (The sensor must be insulated to the output flow.)

Fit the pipe on the drop shaft.

Fit the hopper and auger so that the pipe slopes.

(PELLETS MUST NOT GET STUCK IN THE PIPE.)

Manual

NBE pellet system