Installation Guide For Opop / Nbe Boiler - Opop H 418 Manual

INSTALLATION GUIDE FOR OPOP / NBE BOILER

General guidelines:
The boiler should be installed by an authorized fitter and must
be installed in accordance with work supervision publication 42 ( Danish ) covering equipment working with
water. The outlet duct should be no longer than 1m, and should be fitted with a cleaning door.
The chimney draught should be at least 5 PA and should be stable, a draught stabilizer should always be
installed. If combustion gases condense in the chimney (wet ash) install a draught stabilizer in the chimney,
or open the flue (the flap inside at the back of the boiler) as wide as possible to increase the temperature
of the smoke. The boiler must be spanned with a bypass to ensure the back flow is always kept above
45 degrees.
Installing the burner into the boiler:
1. Install the burner on the side of the boiler
(there should be no shield on the burner, when using the comfort boiler ).
2. Fit the controls either on the cabinet or on the wall.
3. Install the overheating safety cut off into the pocket on the side of the boiler, and connect the
controls so that the overheating safety cut off will cut the power if the boiler overheats.
4. Install the heat sensor on the output flow, either in the pocket or by the sensor on the output
flow. (The sensor must be insulated to the output flow.)
5. Fit the pipe on the drop shaft.
6. Fit the hopper and auger so that the pipe slopes.
(PELLETS MUST NOT GET STUCK IN THE PIPE.)
Manual
NBE pellet system
NBE / OPOP
A Height
B Depth
C Width without burner
D Height smoke pipes
E Height Returns
F Height Output
Smoke tube outer D
Pipe connections
Pipe connections
Weight
Water content
Hole to burner H x B
Diag. Example of installation
30 S 60 M 80 L
1142 1272 1272
750 896 1003
513 643 743
885 997 997
276 276 283
1030 1161 1154
130 150 180
3/4" 1" 1 ¼"
½" ½" ½"
250 300 350
75 105 125
152x132 180x180 248x248