Advertisement
3.
Line up the hole in the rail with the hole at the front of the drawer and secure with countersunk
screw, nut and lockwasher.
NOTE: countersunk screw must be fitted from inside the rail with the nut and lockwasher inside the drawer.
Once both drawers are fitted and secured, tighten all woodscrews securing drawer runners to the
bench top.
Carefully with assistance, turn the bench top assembly over, ensuring the drawers are between both
legs, line up the securing holes in the tops of legs with the pre-drilled holes in the bench top and
secure with woodscrews, DO NOT fully tighten until all six screws are fitted.
Fit the leg (23) in position under the R/H side of the bench top, line up the securing holes as with the
other two legs and loosely secure with woodscrews.
Secure leg to angle brackets using M5x8 screws, nuts and lockwashers, DO NOT tighten until all screws are in
place, tighten all screws including the woodscrews securing the brackets to the bench top. Finally wind the
feet down sufficiently to support the R/H side of the work bench and secure with locking nut.
1.
Fit the 3 drawer runners (10 Type 'C') to the L/H
leg. This is carried out simply by inserting the
tongue's into the slots in the L/H leg as in diag,
allow the runner to swing down in direction of
arrow and come to rest against the leg, hence
holding itself in position, (no fixings are required).
Repeat for opposing runners (9 Type 'B') to the left
hand face of the cross panel.
2.
Attach the drawers to the runners as before (Fitting Drawers) starting at the bottom and
working upwards.
The shelf has a right angle lip at the back with a 'U' shaped lip on the front. The shelf is fitted with the
lips facing downwards with the largest cut out at the back and to the R/H side.
The shelf is simply fitted by inserting into cupboard at an angle, then just resting on the shelf brackets
either side.
IMPORTANT Ensure the key remains in the lock until lock is fully fitted.
Remove the locking lever securing screw and lock washer from the lock assembly, remove the lever
and wavy washer noting which way round they are fitted for reassembly. Take care not to ensure
the barrel does not fall out of the lock body.
Unscrew and remove the large securing nut and washer, insert the lock into the hole in the door, refit
the washer and securing nut and tighten with spanner, DO NOT overtighten.
To determine the position of the locking lever, turn the key fully clockwise (locked position), fit the
lever and wavy washer ensuring the lever is in the locked position, secure with screw and lock washer.
Turn the key anticlockwise to determine the correct rotation for locking and unlocking i.e. anticlockwise
= unlocked and clockwise = locked.
Before using the bench for the first tme, we recommend the application of a propriety waterproof
wood preservative to the bench top to prevent staining from oil spills etc.
Fitting Assembled Top to Base
Fitting Right Hand Leg
Fitting Drawers
Fitting Shelf
Fitting Door Lock
Your workbench is now ready for use.
PARTS & SERVICE TEL: 020 8988 7400
or
e-mail as follows:
PARTS: Parts@clarkeinternational.com
SERVICE:
Service@clarkeinternational.com
Type
'B'
Type 'C'
Advertisement
