Related Manuals for Clarke CWB57
Summary of Contents for Clarke CWB57
- Page 1 WORKBENCH WITH DRAWER LOCKABLE CUPBOARD MODEL NO: CWB57 PART NO: 7642010 ASSEMBLY INSTRUCTIONS LS0115...
-
Page 2: Specification
INTRODUCTION Thank you for purchasing this CLARKE product. Before attempting to use this product, please read this manual thoroughly and follow the instructions carefully. In doing so you will ensure the safety of yourself and that of others around you, and you can look forward to your purchase giving you long and satisfactory service. - Page 3 CONTENTS Description Side Panel Top/Bottom Panel Rear Panel Door Jamb Drawer Base Drawer Sides Feet Door Drawer Runners and Guides 2 sets Drawer Handle Red Drawer Front Wooden Top (Not Shown Fixings kit 12 x M5x10 round head bolt set 19 x M4x8 flat head bolt set 4 x M6x25 hex head self tap screw set 1 x M5x8 round head bolt set...
- Page 4 ASSEMBLY 1. Fit the two side panels (1) to the 3. Insert the Bottom Panel (2) as rear panel (3) as shown, use the shown and fix in place using the fixings (large nuts and large bolts) large nuts, large bolts and supplied to secure in place.
- Page 5 7. Fit the door jamb (4) to the 10. Place the key in the lock and turn opposite side to the hinge pin. it so that the window on the front of the lock turns green. 8. Fully tighten all fixings. 11.
- Page 6 16. Fit one half of the drawer guides 17. Fit the door knob. (9) into position as shown and 18. Fit the wooden top (12) to the use the small machine screws workbench using the coach bolts and nuts to secure in place. and washers provided.
- Page 7 Viewed from below 21. Fit the red drawer front (11) in 22. The drawer runners are marked place and attach the handle (DR and DL), and must be fitted (10) to the drawer using the 2 to the correct side of the drawer screw supplied.