Related Manuals for Clarke CWB1250
Summary of Contents for Clarke CWB1250
- Page 1 WORKBENCH WITH CABINET & DRAWER MODEL NO: CWB1250 PART NO: 6500130 ASSEMBLY INSTRUCTIONS ORIGINAL INSTRUCTIONS GC0917...
-
Page 2: Environmental Protection
Open the carton and lay out the components carefully, identifying them according to the parts list and diagram on pages 6 and 7. Should any part be damaged or missing, please contact your Clarke dealer immediately for replacement. Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com... - Page 3 CONSTRUCTION The cabinet body is constructed from 6 panels plus the door. The top and bottom panels are identical, but the side panels are of two types, one with a shelf support and one without. The unit can be assembled either with the open shelf to the left or right, with the closed cupboard on the other side.
- Page 4 3. Attach the opposite side panel in a similar manner. 4. Add the centre panel, noting that the shelf support bracket must correspond with the bracket on the end panel. 5. Locate the door lower hinge pin into the hole in the lower panel, then place the top panel on top of the two side and...
- Page 5 THE TABLE TOP 1. Turn the table top face down and attach the two drawer runners as shown in fig 4, using three wood-screws each side in the pre- drilled holes in the table top. 2. The table is now ready to be assembled to the cabinet.
-
Page 6: Component Parts
COMPONENT PARTS Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com... - Page 7 COMPONENT PARTS Item Description Part No Table Top RO125001 Top Panel RO125002 Left hand Side Panel RO125003 Right Hand Side Panel RO125004 Centre Panel RO125005 RO125006 Rear Panel RO125007 Bottom Panel RO125008 Door Panel RO125009 Door Lock Assembly RO125010 Drawer Bottom Draw Front RO125011 Drawer Back...