Advertisement
ALWAYS seek assistance when lifting heavy items.
ALWAYS keep children and animals away from tools and work area.
ALWAYS keep work area clean and free from oil spills etc.
Before attempting to assemble the work bench, carefully unpack/unwrap and lay out all components,
check off against the list of contents on front page, notify your Clarke dealer ASAP of any shortages
and/or damage.
Tools required:
Cordless drill and drill bits (4mm and 5mm). Due to manufacturing tolerances, some holes may
not line up accurately and may require opening up in order to fit securing screws.
1 x 12mm open ended spanner.
1 x Medium flat bladed screwdriver.
1 x 8mm ring or combination spanner.
1 x 7mm ring or combination spanner.
1 x Spirit Level.
Optional:
Cordless screwdriver + screwdriver bits, 7mm and 8mm sockets, flexi drive and or nut spinners.
Hint - It may help with assembly to lay the legs and panels on their back edge until the bench is at a
stage where it can be stood on its feet. Ensure some form of protection is laid down to prevent
damage to the painted surfaces.
NOTE : Figures in brackets refer to item numbers in contents list on front page.
1.
Assemble feet (11, 12 & 13) and attach two to each leg. Screw in as far as possible. DO NOT
tighten.
2.
Attach the top panel (4) to the left leg (1) using M5x8 cheese head screws , nuts and
lockwashers, DO NOT tighten at this stage.
NOTE: Top panel has cut out in the front lip for the cross panel to fit into.
3.
Attach the bottom panel (5) with the left leg (1) and loosely secure with screws nuts and
lockwashers.
4.
Attach the middle leg (2) to the upper and lower panels and loosely secure with screws etc.
5.
Attach the cross panel (6) between the upper and lower panels, before loosely securing
with screws, ensure the cross panel is fitted with the shelf bracket facing the middle leg
corresponding bracket and the cut out for the lock to the front of the unit.
6.
Carefully turn the assembly onto its front, attach the back panel and loosely secure with screws etc.
7.
Carefully stand the assembly on its feet.
Upper Panel
Upper Hinge Pin
Lower Hinge Pin
Lower Panel
SAFETY PRECAUTIONS
ASSEMBLY
Base Unit Assembly
8.
Remove the three screws etc securing the
top panel (4) to the right leg (2), this is
necessary to fit the door (3).
9.
Fit the door (3) between the upper and
lower panels as follows:
Place flat washer (spacer) A6 on the
bottom hinge pin, gently pull out the top
Right Leg
of the right leg sufficiently to release the
upper panel (see diag on left), insert the
bottom hinge pin into the hole in the lower
panel, raise the upper panel enough to
allow the top hinge pin to pass under and
locate into the corresponding hole.
Lower the upper panel and reattach to the
right leg and tighten screws etc.
Advertisement
