Advertisement
10.
To ensure the assembly is as square as possible before continuing, position the bench where
it is to be sited. Place spirit level on the upper panel and adjust the feet until the unit is level in
both directions, i.e. front to back and side to side, secure with locking nuts. Once satisfied
the unit is as square as possible, proceed to tighten all screws and nuts, starting in the centre
and working outwards until all are tight, DO NOT overtighten. Check the door is square and
doesn't bind on the upper and/or lower panel.
11.
Carefully lay the bench top upside down on the assembled bench, the arrow denotes the
front of bench top, also the direction the drawers pull out.
Hint - Using if available, a cordless screwdriver/drill, drive woodscrews L5 x 20 fully into all the pre-
drilled holes, DO NOT overtighten. Remove afterwards.
12.
Loosely fit drawer runners (20 & 21 type 'A') with L shaped brackets to bench top.
NOTE: Drawer runners are left and right handed and must be fitted in pairs so that the longest part of
rail protrudes the bracket at the front of bench top.
Type 'A' Drawer Runner
Sliding Rail
13.
Loosely fit the angle brackets (24 & 25) at the points shown below. When fitting brackets,
ensure the front 24 is fitted with the flush side facing outwards.
Bench Top (Underside)
All drawers can be assembled at this stage and placed to one side for later.
NOTE: Drawers are held together using M4x8 cheese head screws, nuts and lockwashers, all
screwheads should be inside of assembled drawer.
Refer to diagram on the front page when assembling.
1.
Attach the front (14) and back (18) to the bottom (15) first, DO NOT tighten screws at this stage.
2.
Attach the sides (16) ensuring the welded angle bracket is at the rear and to the top.
3.
Once the drawer is fully assembled, proceed to tighten all screws and nuts, starting in the
centre and working outwards, keeping the drawer as square as possible.
Fit two drawers to the prepared bench top as follows:
1.
Pull the sliding rails out to the front of bench top as far as possible.
2.
Fit drawer between rails, ensuring the rail fits between the upper lip and the welded bracket
at the back.
'L' shaped bracket
L/H Bracket
Drawer Assembly
Fitting Drawers
Sliding Rail
R/H Bracket
Longest overhang to
front of work bench
Longest overhang to
front of work bench
24
25
Advertisement
