Clarke CWB1250 Instruction

Heavy duty workbench

HEAVY DUTY WORKBENCH

Model CWB1250

0107

Thank you for purchasing this CLARKE Heavy Duty Workbench, which, if treated

with care and respect, will give years of reliable and satisfactory service.

Guarantee

This product is guaranteed against faults in manufacture from 12 months from

purchase date.

Keep your receipt as proof of purchase. This guarantee is invalid if the product

has been abused or tampered with in any way, or not used for the purpose for

which it was intended. The reason for return must be clearly stated. This guarantee

does not affect your statutory rights.

Table of Contents

Do you have a question about the CWB1250 and is the answer not in the manual?

Page 1 HEAVY DUTY WORKBENCH Model CWB1250 0107 Thank you for purchasing this CLARKE Heavy Duty Workbench, which, if treated with care and respect, will give years of reliable and satisfactory service. Guarantee This product is guaranteed against faults in manufacture from 12 months from purchase date.
Page 2 If there are any deficiencies, immediately contact the dealer from where the product was purchased, or the Clarke International Parts Department on, 020 8988 7400. Assembly is quite straightforward and requires the use of a screwdriver and a 10mm spanner Assembly Note: When assembling, all screw heads should be on the outside of the cabinet.
Page 3 PARTS & SERVICE CONTACTS For Spare Parts and Service, please contact your nearest dealer, or CLARKE International, on one of the following numbers. PARTS & SERVICE TEL: 020 8988 7400 PARTS & SERVICE FAX: 020 8558 3622 e-mail as follows: PARTS: Parts@clarkeinternational.com...
Page 4 Assembly Diagram NOTE: Washers and nuts always located on the inside during assembly 1 Worktop RO125001 9 Door RO125009 2 Top Panel RO125002 10 Door Lock RO125010 3 Side Panel (L) RO125003 11 Drawer (5 Panels) RO125011 4 Side Panel (R) RO125004 14 Drawer Guide RO125014...