Selecting The Oob Frequency - Motorola DCT700 Installation Manual

Selecting the OOB Frequency

To select the OOB frequency:
From the OOB STATUS diagnostic, press
1
frequency selection mode. The OSD displays a new MANUAL FREQ line at the bottom of
the screen, indicating the LKC frequency.
Press a second time to exit the frequency change mode.
2
MENU
Or
Press the
CHANNEL
OOB frequency. The frequency selection appears on the MANUAL FREQ line of the OSD.
The first frequency to display is 75.25. The system scrolls through each frequency until it
reaches the last, 103.75, and then scrolls back to the beginning. This diagnostic scrolls
through the OOB frequencies in the following order:
75.25 MHz
!
104.20 MHz
!
72.75 MHz
!
92.25 MHz
!
98.25 MHz
!
107.25 MHz
!
107.40 MHz
!
110.25 MHz
!
116.25 MHz
!
103.75 MHz
!
Press to begin searching for the OOB frequency.
3
SELECT
On the OSD the MANUAL FREQ line of text clears, the HUNT MODE displays FIX to
indicate the fixed frequency search, and the CUR FREQ field changes to the frequency
selected to search.
If the frequency is found with the proper EMM Provider ID, the OSD LKC field changes to
display the new frequency.
If after 40 seconds the frequency search is not successful, the set-top performs a warm reset
and returns to the last known carrier frequency.
To abort a search without waiting the 40 seconds, press
4
MENU
or cursor keys to scroll through the frequencies to locate the desired
Diagnostics
on the remote control to enter the
to cause a warm reset.
POWER
DCT700 Installation Manual
B-7