Snmp Workflow; Supported Mibs - Cisco SF 300-08 Administration Manual

Configuring SNMP
SNMP Versions and Workflow
NOTE
Cisco Small Business 300 Series Managed Switch Administration Guide

SNMP Workflow

The switch comes with SNMP turned off by default. Before you can configure
SNMP, you must turn on SNMP by using
The following is the recommended series of actions for configuring SNMP:
If you decide to use SNMP v1 or v2:
Define a community by using the
can be associated with an access rights and view in Basic mode or with a group in
Advanced mode. (See the Communities Page for information on Basic and
Advanced modes.) There are two ways to define access rights to a community:
• Basic mode - The access rights of a community can configure with Read
Only, Read Write, or SNMP Admin. In addition, you can restrict the access to
the community to only certain MIB objects using a view. views are defined in
the SNMP Views Page
• Advanced Mode - The access rights to a community is defined by a group.
You can configure the group with a specific security model. The access
rights in a group is defined by the Read, Write, and Notify access to the
desired views Groups are defined in the SNMP Views Page.
If you decide to use SNMP v3:
1. Define the SNMP engine, one time, by using the
2. If desired, define SNMP view(s) by using the
3. Define groups by using the
4. Define users by using the SNMP Users Page
with a group.
Traps and Notifications Management for SNMP v1, v2, or v3:
1. Enable or disable traps by using the
2. Optionally, define a notification filter(s) by using the
3. Define a notification recipient(s) by using the
Page SNMPv3 Notification Recipient Page
and/or

Supported MIBs

The following standard MIBs are supported:
• CISCO-CDP-MIB.mib
Security-> TCP/UDP Services.
Add SNMP Community Page.
Engine ID Page.
SNMP Views Page.
Groups Page.
,
where they can be associated
Trap Settings Page.
SNMPv1,2 Notification Recipient
19
The community
Notification Filter Page.
, respectively.
276