Save Configuration; Configure Additional Switch; Configure Data Center Bridging (Dcb) (Optional); Disable Iscsi - Dell S4048-ON Configuration Manual

Switch configuration (OS 10.x)
3.1.13

Save configuration

OS10#copy running-configuration startup-configuration
OS10#reload
System configuration has been modified. Save? [yes/no]: yes
Proceed to reboot the system? [confirm yes/no]:yes
3.1.14

Configure additional switch

Repeat the commands from section 3.1 to configure the second switch.
Note: The preceding procedure places all switch ports in the default VLAN. If you prefer to place ports in a
non-default VLAN, refer to the switch documentation.
3.2

Configure Data Center Bridging (DCB) (optional)

To enable DCB mode on the switch, use the following commands.
Note: You must complete the Dell EMC recommended switch configuration steps in section 3.1 before
configuring the switch for DCB mode.
3.2.1

Disable iSCSI

OS10# configure terminal
OS10(config)# no iscsi enable
OS10(config)# no iscsi session-monitoring enable
3.2.2

Disable 802.3x flowcontrol on all ports

OS10(config)# interface range ethernet 1/1/1–1/1/48
OS10(conf-range-eth1/1/1-1/1/48)# no flowcontrol receive
OS10(conf-range-eth1/1/1-1/1/48)# no flowcontrol transmit
OS10(conf-range-eth1/1/1-1/1/48)# exit
OS10(config)#
3.2.3

Enable DCB

OS10(config)# dcbx enable
22 Dell EMC Networking S4048-ON Switch Configuration Guide for Dell PS Series SANs | SCG1026