Delete Startup Configuration; Configure Out Of Band (Oob) Management Port; Configure Login Credentials; Configure Qspf Ports To 4 X 10Gbe Breakout Ports - Dell S4048-ON Configuration Manual

Switch configuration (OS 10.x)
3.1.3

Delete startup configuration

Note: The following commands will delete all configuration settings.
OS10# delete startup-configuration
Proceed to delete startup-config [confirm yes/no(default)]yes
OS10# reload
System configuration has been modified. Save? [yes/no]no
Proceed to reboot the system? [confirm yes/no]yes
Note: The switch will reboot.
3.1.4

Configure out of band (OOB) management port

After the startup configuration is deleted, the factory default password is admin.
OS10# configure terminal
OS10(config)# interface mgmt 1/1/1
OS10(conf-if-ma-1/1/1)# no ip address dhcp
OS10(conf-if-ma-1/1/1)# ip address <ipaddress>/<subnet>
OS10(conf-if-ma-1/1/1)# exit
OS10(config)#
3.1.5

Configure login credentials

OS10(config)# username admin password $0$<password>
3.1.6

Configure QSPF ports to 4 x 10GbE breakout ports

QSFP ports can be configured as breakouts to be used with 10GbE iSCSI storage or server network
adapters. To configure these ports as 4 x 10GbE ports, use the following commands.
OS10(config)# interface breakout 1/1/<port-number> map 10g-4x
OS10(config)# exit
OS10#
Use the following command to check port interface status.
OS10# show interface status
19 Dell EMC Networking S4048-ON Switch Configuration Guide for Dell PS Series SANs | SCG1026