Configure Login Credentials; Configure Switch Ports; Save Configuration And Reload - Dell S4048-ON Configuration Manual

Switch configuration (OS 9.x)
2.4.8

Configure login credentials

Dell(conf)#username admin privilege 15 password 0 <yourpassword>
Dell(conf)#enable password level 15 0 <yourpassword>
2.4.9

Configure switch ports

Dell(conf)#interface range tengigabitethernet 1/1–1/48
Dell(conf-if-range-te-1/1-48)#mtu 12000
Dell(conf-if-range-te-1/1-48)#switchport
Dell(conf-if-range-te-1/1-48)#spanning-tree rstp edge-port
Dell(conf-if-range-te-1/1-48)#flowcontrol rx on tx off
Dell(conf-if-range-te-1/1-48)#no shutdown
Dell(conf-if-range-te-1/1-48)#exit
Dell(conf)#interface range tengigabitethernet 2/1–2/48
Dell(conf-if-range-te-2/1-2/48)#mtu 12000
Dell(conf-if-range-te-2/1-2/48)#switchport
Dell(conf-if-range-te-2/1-2/48)#spanning-tree rstp edge-port
Dell(conf-if-range-te-2/1-2/48)#flowcontrol rx on tx off
Dell(conf-if-range-te-2/1-2/48)#no shut
Dell(conf-if-range-te-2/1-2/48)#exit
Dell(conf)# protocol spanning-tree rstp
Dell(conf-rstp)#no disable
Dell(conf-rstp)#exit
Dell(conf)#exit
2.4.10

Save configuration and reload

Dell#copy running-config startup-config
Reload the stack to allow settings to take effect:
Dell#reload
Note: The preceding procedure places all switch ports in the default VLAN. If you prefer to place ports in a
non-default VLAN, refer to the switch documentation.
17 Dell EMC Networking S4048-ON Switch Configuration Guide for Dell PS Series SANs | SCG1026