Configure Out Of Band (Oob) Management Port; Configure Login Credentials; Configure Jumbo Frames; Enable Flow Control - Dell PowerConnect 8024 Configuration Manual

2.6

Configure out of band (OOB) management port

console(config)#interface out-of-band
console(config-if)#ip address ipaddress mask gateway
console(config-if)#exit
2.7

Configure login credentials

console(config)#line telnet
console(config-telnet)#login authentication default
console(config-telnet)#exit
console(config)#ip http authentication local
console(config)#username admin password yourpassword privilege 15
console(config)#enable password yourpassword
2.8

Configure Jumbo Frames

console(config)#interface range tengigabitethernet all
console(config-if)#mtu 9216
console(config-if)#exit
2.9

Enable flow control

console(config)#flowcontrol
This operation may take a few minutes.
Management interfaces will not be available during this time.
Are you sure you want to continue? (y/n)y
2.10

Configure spanning tree portfast on edge ports

console(config)#interface range tengigabitethernet 1/0/1-20
console(config-if)#spanning-tree portfast
console(config-if)#exit
8 SCG1008 PowerConnect 8024, 8024F, M8024 and M8024-k Switch Configuration Guide for EqualLogic SANs