Table of Contents
Advertisement
END OF CYCLE
BEEPS
NUMBER OF BEEPS
Light on
TIME SAVER
= 15 beeps
SOAK
=
SOFTENER
RINSE
= no beeps
DEFAULT RINSE
OPTION
RINSE OPTIONS
1st
Light on
rinse rinse
MED spin
deep deep
rinse rinse
SLOW spin short deep
spin
HOLD
spray deep
rinse rinse
VOLUME OF WATER
USED IN THE
SHOWER RINSE
(REGULAR CYCLE)
SHOWER RINSE VOLUME
Light on
HIGH = more water
MED = more water
LOW = FACTORY SETTING
CONTROLLED COLD
CHANGING PRE-SET OPTIONS
The beeps signaling the end of the cycle can be
increased or decreased.
1. Enter the Option Adjustment Mode.
2. Use the WASH OPTION button to select the
5 beeps
number of beeps you prefer.
3. Press POWER to store your selection.
The normal rinse on the Regular and Heavy Duty cycles is
a Shower Rinse.When you select Softener Rinse on these
2nd
cycles the rinse changes to the default rinse. The default
rinse is the rinse option used on the Wool, Delicate and
Permanent Press cycles.The default rinse is a spray rinse
followed by a deep rinse. However you can change the
default rinse to a single deep rinse or two deep rinses.
1. Enter the Option Adjustment Mode.
rinse
2. Use the SPIN SPEED buttons to select the rinse
option you prefer.
3. Press POWER to store your selection.
You can increase or decrease the volume of water
added during the shower rinse on the Regular cycle.
1. Enter the Option Adjustment Mode.
2. Use the WATER LEVEL buttons to select the
volume of water you wish to be used in the
shower rinse.
3. Press POWER to store your selection.
The ecosmart is designed for installations that have
both hot and cold water. To ensure optimum
performance even in very cold weather, the cold
water temperature is controlled to 60ºF. However if
for some reason you do not have hot water available
you may need to change to uncontrolled cold in very
cold weather.
Ecosmart leaves the factory with the Controlled
Cold Option. You can change this by pressing the
ADVANCE button.
17
Advertisement
Table of Contents
