Thermal Fuse Protection; For Best Performance - Carpet Pro CPU-1 Operating Instructions Manual

Your Carpet Pro vacuum cleaner comes equipped with a Manual Reset Thermal Fuse Protector. This thermal
protector is designed to protect your vacuum cleaner from overheating due to a cutoff in airflow (i.e. clogged
hose, operating the vacuum without a bag). Should this situation occur, the thermal fuse protector will safely shut
off your vacuum cleaner to avoid any potential damage.
For models CPU-1 and CPU-1T only
NOTE: To determine if it was the thermal fuse protector that turned off your vacuum cleaner and not some other reason,
please refer to the vacuum cleaner's headlight. If the headlight is on while the motor is off, then the thermal fuse did
safely shut down the motor. If the headlight and motor are off, then there is some reason other than the thermal protector
(i.e. pulled plug) the vacuum cleaner has shut down.
To reset the thermal fuse
1. Unplug the vacuum cleaner.
2. Check for problem (over-filled bag, clog in hose, clogged filters, etc.).
3. Correct problem.
4. Locate "tripped" fuse — the small red button located on the bottom of the back side of the main body (roughly
one inch to the right of the left wheel).
5. Using a pencil, paper clip, or other pointy object, push the reset button.
6. Plug vacuum cleaner in and begin using.
Please return to your Carpet Pro Retailer with any questions.
• Keep machine and all accessories clean and in good operating condition.
• Change vacuum bags and filters as recommended to maintain optimum cleaning efficiency.
• Always use genuine bags, filters and parts, as use of other products may result in poor cleaning or filtration
performance. Carpet Pro filtration products are designed for maximum performance.
• Have machine checked periodically by the retailer where you purchased your Carpet Pro vacuum.
• Store machine carefully in dry area.
• For optimum cleaning performance and safety, follow your owner's manual.
10

Thermal Fuse Protection

For Best Performance