Simrad R3016 12U/6X Installation Manual page 20

20
1
2
7
3
1 Temperature sensor mounting screw holes
Pan head screws are inserted here to retain the sensor
2 Lower heater element mounting hole
Lower element is directly inserted into this hole
3 Lower heater element retaining screw hole
Pan head screw is inserted here to retain the element
4 Upper heater element mounting hole
Upper element is directly inserted into this hole
5 Upper heater element retaining screw hole
Pan head screw is inserted here to retain the element
6 PCB mounted cable clip
Pass a heater loom through this clip
7 Mounting foot
Cable a tie loom to this point
8 Heater loom route
Follows a route of existing cables. Ensure the loom is secured to the existing loom
at regular intervals using cable ties. Pass the loom through any cable clip that is
used to support existing cables.
Hardware mounting | R3016 12U/6X Installation manual
6
8
4
5