Adding The Heater System (Optional) - Simrad R3016 12U/6X Installation Manual

18

Adding the heater system (optional)

An optional heater can be installed to ensure transceiver reliable operation down to -40 °C.
The heater kit consists of an R3000 power supply, and the heater components and fasteners
for inside the transceiver. The heater power cable must be ordered separately in a length
suited to the installation. The power cable is the same type as used for powering the
transceiver.
Heater kit parts
2
1
1 Heater element
2
Connector (female) for temperature sensor
3
In-line fuse holder (10 A SB fuse)
4 External waterproof socket
5
Thermo-conductive gel
6 Temperature sensor
7
2 x hex pan screws M4
8
2 x hex pan head screws M3
Tools required
The following list covers the basic tools that are essential to installation the heater kit:
• Screwdriver Torx - T20
• Screwdriver Torx - T10
• Hex key – 6 mm
Install the heater R3000 power supply unit
As the heater power supply housing is identical to the transceiver power supply unit, use the
"Install the R3000 power supply unit" on page 16 for instructions.
Hardware mounting | R3016 12U/6X Installation manual
5
3
6
4
7
8