Simrad R3016 12U/6X Installation Manual page 19

Install heater kit in transceiver housing
Ensure the radar system is shut down, and a warning sign has been placed at the controller.
When at the up-mast transceiver set the safety switch in the (power) OFF position.
Remove the two pan head screws securing the blanking plate found between the Ethernet
port and the safety switch on the rear of the up-mast transceiver.
Pass the heater elements, spade connectors, and fuse holder through the hole, from outside
to the inside.
Secure the plug body to the transceiver housing with existing fasteners.
Inside the up-mast transceiver identify the temperature sensor and heater element
mounting locations by referring to the following diagram. Route the Heater kit loom along
the dotted line shown. Ensure no part of the cable has enough slack to risk coming in to
contact with moving parts like the main gear wheel.
Secure the temperature sensor with two supplied M3 pan head screws, and slide on the blue
spade connectors. Insert the heater elements into the mounting holes and secure them in
place using supplied M4 pan head screws.
Hardware mounting | R3016 12U/6X Installation manual 19