Display And Speaker Output During Multiple Connections; Configuring The Settings Using The Web Menu - Yamaha PJP-50R Basic Operation Manual

Display and speaker output during
multiple connections
The information display and speaker output method vary
depending on the settings in "Connection Mode" (page 14
in the "Setup guide" (a separate manual)) and "Speaker
Mode" (page 17 in the "Setup guide" (a separate
manual)).
■ When the "Speaker Mode" is set to
"Multi"
192.168.100.20
192.168.100.30
192.168.100.40
Menu :Address
IP address of other units
The audio from each location is output from a different
position.
, and displayed before the IP address of each
location indicate the positions of the speakers where the
audio from respective locations are output.
Positions in 4-location call
3 VOL
2
1 6
5 MIC MUTE
4 9
8 #
7 0
■ When "Speaker Mode" is set to
"Monaural"
[1] 192.168.100.20
[2] 192.168.100.30
[3] 192.168.100.40
Menu :Address
IP address of other units
The audio from other locations is not divided according to
locations, but are mixed and output as monaural audio.
The order of connections is displayed before the IP
addresses of other units.
Positions in 3-location call
3 VOL
2
1 6
5 MIC MUTE
4 9
8 #
7 0
y
For the display during communication using the SIP server, refer
to "Display in SIP server operation" (page 25) in the "Setup
guide" (a separate manual). For the display during
communication with cascade connections, refer to "Display in
cascade connection" (page 28) in the "Setup guide" (a separate
manual).
■ Display with simultaneous use of
telephone circuit
After connecting the locations with mesh connection
through the IP network, each location can call an
additional location through the telephone circuit.
When a location is connected through the telephone
circuit, it is displayed as shown below.
192.168.100.20
192.168.100.30
192.168.100.40
408467
Menu :Address
■ To end communication
Press . If the communication includes a telephone
circuit connection, select the connection that you want to
disconnect in the Select Disconnection display, and press
.
Select Disconnection
1. ALL
2. IP
3. Phone
Select Disconnection options
• ALL: Ends all connections.
• IP: Ends connections through IP network.
• Phone: Ends connections through telephone circuit.
Talking with Multiple Locations
13