Sending Tone Signals; Transferring A Call (Telephone Circuit Only) - Yamaha PJP-50R Basic Operation Manual

Sending tone signals

Tone signals can be transmitted during communication.
This is convenient when using a service that requires tone
input during a call, such as the answering service of a
cellular phone.
1
Press during communication.
The display for additional number entry appears.
2
Press the numeric keys to enter the required
number.
The corresponding tone is transmitted.
y
When "Dial Type" is "20PPS" or "10PPS" (pulse dialing),
press * to select tone dialing and then enter the telephone
number. The dial type returns to the original pulse dialing
speed after the end of the call.
3
After completing the number entry,
press .
The display during communication reappears.
Operations during Communication through Telephone Circuit
Transferring a call
(Telephone circuit only)
A received call can be transferred to another extension
phone provided that the PBX accommodating this system
is compatible with hooking-activated call transfer.
Note
This function is available only when both the transfer source and
transfer destination are connected to the analog public switched
telephone circuits. This function is not available if the PBX in use
does not have the hooking-initiated transfer function.
1
Press during communication through
the telephone network.
The call is held, and the display for entering the
transfer destination telephone number is displayed.
2
Enter the telephone number of the transfer
destination with the numeric keys.
The transfer destination telephone starts to be called.
y
• You do not have to enter the prefix before the telephone
number.
• If you want to cancel the call of the transfer destination or
if the transfer destination does not answer the call, press
to resume the call that has been held.
3
When the transfer destination answers the
call, press during the communication.
The transfer destination is connected to the transfer
source, and this unit is disconnected from the call.
y
• If the transfer destination disconnects the call before it is
connected to the transfer source, this system is returned to the
communication with the transfer source.
• You can set the hooking signal transmission time according to
the PBX in use. For details, see "Setting the hooking signal
transmission time" (page 15) in the "Setup guide" (a separate
manual).
19