Communication through Telephone Circuit
Communication through Telephone Circuit
Calling another party
To place a call to another party, enter its telephone number.
CAUTION
• Before using the functions of this system, it is necessary to install, connect, and set up the system. For details,
refer to the "Setup guide" (a separate manual).
• Before using this function, it is necessary to set the country code. For details, refer to "Setting the country using
the telephone function" (page 16) in the "Setup guide" (a separate manual).
1
Press
repeatedly until the initial display
appears.
Make sure that "Tel & IP ready"or "Tel ready" appears
in the display.
Tel ready
2007.09.20 12:16:14
Menu
14
/ STANDBY
:Address
Numeric keys
VOL
3
2
6
1
MIC MUTE
5
9
4
8
#
7
0
HOOK
MIC MUTE
2
Enter the telephone number of the called
location with the numeric keys.
Number
[ ] [#] 0-9
If you make an entry mistake, press
numbers, and then enter the correct numbers by using
the numeric keys again.
3
Press
.
The calling display appears.
^
408467
[ ]
VOL +/–
4084
to delete the
:Cancel
[#]