Front Panel Connection - Danfoss OPTYMA Operation And Maintenance Manual

OPTYMA Control three-phase Operation and Maintenance Guide
TM

Front panel connection

Re-attach the front panel and reconnect the elec-
tronic card connector as shown below.
1.
Re-attach the front panel to the lower part of the
housing by inserting the two hinges in their seats.
2.
Bend the hinges and rotate the front panel
downwards 180° to gain access to the inside of the
housing and then reconnect the electronic card
connector.
3.
When using Alarm/Aux relay, connect the wiring
directly to the electronic card clamps.
It is advisable to route these wires alongside the
connection cables from the electronic card and the
housing back panel.
© Danfoss A/S (RA Marketing/MWA), Nov. 08
12 RS8FE102, 080R9278