Led Display; General; Symbols Used; Setting And Displaying The Setpoints - Danfoss OPTYMA Operation And Maintenance Manual

OPTYMA Control three-phase
TM

LED display

General

To enhance safety and simplify the operator's work,
the OPTYMA Control has two programming
TM
levels; the first level (Level 1) is used to configure
the frequently-modified SETPOINT parameters. The
second programming level (Level 2) is for general
parameter programming of the various controller
operating modes.

Symbols used

For practical purposes the following symbols are used:
• () the UP key
• () the DOWN key

Setting and displaying the setpoints

1. Press the SET key to display the current SETPOINT
(temperature)
2. Hold down the SET key and press the () or ()
keys to modify the SETPOINT.
Release the SET key to return to cold room
temperature display: the new setting will be saved
automatically.
© Danfoss A/S (RA Marketing/MWA), Nov. 08
is used to increase values and mute the alarm.
is used to decrease values and force defrosting.
RS8FE102, 080R9278
Operation and Maintenance Guide
1. Cold room temperature / parameters
2. Stand-by (flashes on stand-by. Outputs are de-
activated)
3. Room light (flashes if door switch is activated)
4. Cold (indicates activation of compressor)
5. Fans
6. Defrosting
7. Auxiliary
8. Alarm/warning
It is not possible to access the Level 2 programming
directly from Level 1: you must exit the programming
mode first.
17