1 Introduction
1-4-2
BOOTP Client
You set the EtherNet/IP Unit in the BOOTP settings to use the BOOTP client to obtain settings, such as
the EtherNet/IP Unit IP address.
BOOTP server
BOOTP command
IP address
BOOTP client
The EtherNet/IP Unit IP address is obtained from the
BOOTP server when the power is turned ON.
1-4-3
FTP Server
An FTP server is built into the EtherNet/IP Unit so that files can be read from and written to the SD
Memory Card in the CPU Unit of the Controller from computers at other Ethernet nodes. This makes it
possible to exchange data files between a host computer and the Controller with the host computer as
the FTP client and the Controller as the FTP server.
SD Memory Card
Host computer to Controller
File data
SD Memory Card
1-18
EtherNet/IP Unit
Host computer
(FTP client)
Ethernet
FTP command
EtherNet/IP Unit
NJ-series Controller
SD Memory Card
CJ-series EtherNet/IP Units Operation Manual for NJ-series CPU Unit (W495)
Ethernet
EtherNet/IP Unit
Controller to Host computer
File data