Controlling The Traceroute Test; Test Results - Cisco GS7000 Installation And Operation Manual

Chapter 5 Using the Web Interface
Input Parameters
Traceroute size
Port

Controlling the Traceroute Test

The Traceroute Test is controlled by the following buttons.
Button
Start Test
Abort Test
Clear Results

Test Results

Below the test control buttons is a text area that displays the results of the Traceroute
test. Any issues with the parameters will be displayed at the top of the results box.
During a test, the web page will automatically refresh to show the current results.
This refresh stops once the test is completed.
The results area permits the user to select results and copy them for pasting into
another program. You access this feature using one of the standard web browser
methods:
Left-click the box and press Ctrl-A (select all)

Right-clicking in the box and click Select all

60
Description
Range is 0 to 1518. 0 is the standard size, resulting in packets
of 40 bytes inclusive of all overhead.
Port to use. Standard is 33434 as the initial port.
Description
Starts the Traceroute test. Each of the values provided in the
input fields is evaluated for validity.

If the host name field is blank, the test will not proceed.
(The exception is leaving it blank when a previous name
had been entered. In that case that name will be used.)

Range checking on the parameters. Any parameter out
of range will be ignored, and the default value used.
Any issues with the parameters will be displayed at the top
of the results box. When the test is started, the web page will
begin to automatically refresh. This message also appears,
indicating the parameters actually in use:
Traceroute in use from <source>; max TTL xxx; size yyy;
port nnnnn
This message is also in the text box.
Stops any traceroute test currently in progress.
Clears the results window.
4037424 Rev A