Hsia Diagnostics Page: Traceroute Command; Input Parameters - Cisco GS7000 Installation And Operation Manual

HSIA Diagnostics Page: Traceroute Command

The HSIA-Traceroute Web Interface is accessed from the Connection form that is
first displayed when the transponder is accessed.
Click the Traceroute button to view the traceroute diagnostics page. The page
appears as shown in the following example.

Input Parameters

Input Parameters
Target IP address or name Either a standard IPv4 dotted-quad address or a host name
Traceroute from what
source
Max hops
4037424 Rev A
Description
is entered. The address entered will be unconditionally
given to the DNS resolver; a dotted-quad will be resolved
the same value, and a name will be resolved to its IPv4
address. The final IPv4 address to be Tracerouted is shown
in parenthesis beside the host field.
There are up to three choices, depending on what is
available in the unit:

Cable Modem: always available

CPE: available if the CPE stack is activated

EMTA: available if the VoIP stack is licensed and
activated
Range is 1 to 255; default is 30. Also known as Max TTL,
which is Maximum Time-to-Live.

HSIA Diagnostics Page: Traceroute Command

59