Chapter 2 Installation - Cisco GS7000 Installation And Operation Manual

4037424 Rev A
2 Chapter 2
Installation
Cable modem infrastructures are likely to have unique characteristics.
For this reason, we strongly recommend that you completely install
one transponder and make it operational before deploying the entire
system throughout your network.
Installing the transponders and making them operational consists of
the following steps, which are explained in detail in this chapter:
Provisioning the transponders in the network

Adding configuration data to the cable modem configuration file

Installing the transponder

Powering the transponder and checking the LEDs for status

In This Chapter

Provisioning the Transponders in the Network ............................... 10

Your Network Information ................................................................. 11

Cable Modem Configuration File ....................................................... 12

Installing the Transponder .................................................................. 13

Configuring the Transponder Using the SA-HMS-
FIBERNODEGS7000 MIB..................................................................... 21

Downloading Module Firmware Using the CTLP-
DOWNLOAD-MIB ............................................................................... 24

Checking the LEDs ............................................................................... 26
9