Cisco GS7000 Installation And Operation Manual page 41


downloadAdminStatus (OID 1.3.6.1.4.1.2082.5.10.1.1.4) – Begins the
download to the module(s).
–
–
–
–

downloadOperStatus (OID 1.3.6.1.4.1.2082.5.10.1.1.5) – Reflects the
operational status of the firmware download. The following are the possible
states.
–
–
–
–
–
–
–
–
–

downloadMessage (OID 1.3.6.1.4.1.2082.5.10.1.1.6) – A text message
providing the latest download status information.
4037424 Rev A
startDownload(1) – Begins the download to the modules with version
checking enabled. If a module is running the same version of firmware
that is being downloaded, it will not receive the firmware download.
While in the process of downloading in this fashion, the
downloadAdminStatus will report startDownload if read.
forceDownload(2) – Begins the download to the modules regardless of
the current version of firmware running or any other factors that may
cause a download not to be performed. While in the process of
downloading in this fashion, the downloadAdminStatus will report
forceDownload if read.
allowProvisioning(3) – Not supported in this application. Although this is
not supported for application and does not affect anything if set. It is also
the default state of downloadAdminStatus.
ignoreProvisioning(4) – When set, firmware upgrade information is
disregarded. After a download is completed, the downloadAdminStatus
will report ignoreProvisioning.
Downloading(1) – Downloading the file to the transponder.
Programming(2) – Programming of the module in progress.
completeProvisioning(3) – Not supported in this application. Indicates
the provisioning upgrade has completed.
completeManagement(4) – startDownload or forceDownload completed
successfully.
completeWithExceptions(5) – Indicates that the firmware download has
completed, but one or more modules failed to download the firmware
successfully.
failedTftp(6) – Transfer of the file failed.
failedCrc(7) – Firmware file CRC error.
failed Timeout(8) – Device did not respond when firmware download
attempted.
Failed Other(9) – An unknown error occurred when attempting the
firmware download.
Downloading Module Firmware Using the CTLP-DOWNLOAD-MIB
25