135: Indent ribbon supplies out
The embosser does not have usable indent ribbon.
1.
Open the embosser and remove the indent ribbon cartridge.
2.
Install a new indent ribbon.
3.
Replace the cartridge, and then close and lock the embosser.
H
& T
INTS
IPS
Refer to
"Load the Indent Ribbon Cartridge"
136: Indent ribbon break
The embosser indent ribbon is not moving properly.
1.
Open the embosser and remove the indent ribbon cartridge.
2.
Reposition, repair, or replace the ribbon and advance the repaired area one full turn.
3.
Replace the cartridge, and then close and lock the embosser.
H
& T
INTS
IPS
Refer to
"Load the Indent Ribbon Cartridge"
Topping Foil"
on
137: Embosser wheel error
The card path is blocked in the embosser.
1.
Open the embosser and remove the supply cartridges.
2.
Remove any cards found.
3.
Replace the cartridges, and then close and lock the embosser.
138: Embosser indent error
The embosser indent ribbon is not moving properly.
1.
Open the embosser and remove the indent ribbon cartridge.
2.
Reposition, repair, or replace the ribbon and advance the repaired area one full turn.
3.
Replace the cartridge, and then close and lock the embosser.
78
page
62.
on
page 33
for more information.
on
page 33
or
"Repair Broken Indent Ribbon or
Troubleshooting