Extreme Networks Extreme Wireless WSAP3825i Installation Manual page 24

WS-MBI-WALL-01 Mounting Bracket on Wall or Solid Ceiling
The WS-MBI-WALL-01 can be mounted on a junction/gang box, wall, or a solid ceiling. When mounting
on a solid ceiling, it is required that you use a Kensington lock or an equivalent lock.
To mount the WS-MBI-WALL-01 bracket on a wall or solid ceiling:
1
Figure 13: Beveled Holes for Wall or Solid Ceiling Mounting (WS-MBI-WALL-01)
2 Mark the centers of the four beveled hole locations. Drill those locations and insert screw anchors if
the wall is made of drywall, plaster, or plaster-board.
3 Attach the bracket with four screws in the anchors. Tighten the screws to 9.0 inch-lbs.
4 Attach the LAN cable(s) to the AP and place the remaining cable length(s) back as desired.
5 Align the AP3825 mounting holes onto the two mounting circles and slide it down.
6 Attach a Kensington lock (or an equivalent lock) through the lower left tab and into the AP, if
desired, to prevent easy removal or minimize AP movement. This step is required for mounting on a
ceiling, and optional for wall mounting.
LAN/Console Connections
Note
Lan/Console connectors with shrouds will not fit into the ports. An optional jumper cable may
be used or the shroud removed.
ExtremeWireless™ WS-AP3825i & WS-AP3825e Installation Guide for version .
Installation
24