Extreme Networks Extreme Wireless WSAP3825i Installation Manual page 27

4 Click Professional Install.
The Professional Install Dialog displays.
5 Modify the Radio Antenna Type as follows:
•
If attaching triple port antennas, all three RF port should be configured with the same antenna
type.
•
If attaching dual port antennas, two of the radio RF ports should be configured with the same
antenna type and the third (non-active port) should be configured to None.
•
If attaching single port antennas, radio ports where antenna should be connected has to be set
to the antenna type and non-active port should be set to None.
6 Modify Radio Attenuation as follows:
•
Add any attenuation (dBm non-negative) due to cable loss or attenuator added to the line
between AP port and the antenna.
•
Same attenuator loss is assumed and is required for all three ports of the radio except when one
or more port is not connected to the antenna and is properly terminated as describe in next step.
•
Professional installer is responsible for accurately configuring port Attenuation. In no case, port
attenuation should be configured higher than actual attenuation between the AP port and the
antenna.
7 Install a terminator (rf 50 Ohm) on all ports where an antenna is not connected.
Configuring Radio Channel
1 Click the APs button in the left pane, then in the Wireless AP list, select the Wireless AP whose
properties you want to modify.
The AP Properties tab displays Wireless AP information.
2 Click the Radio 1 tab.
ExtremeWireless™ WS-AP3825i & WS-AP3825e Installation Guide for version .
Installation
27