Extreme Networks Extreme Wireless WSAP3825i Installation Manual page 22

1 Attach the WS-MBI-DCU01 to the AP using the screws provided. If needed, pull the handle and slide
the top piece to access the additional screw holes that are underneath the handle. The four screw
holes are indicated by the green arrows in the
Figure 11: Sliding Handle and Screw Holes
2 Move the ceiling tile away from the T-bar.
3 Raise the locking bracket handle slightly and open the space between clips so that the space is
wider than the T-bar.
4 Put the stationary side of the bracket hooks on the T-bar.
5 Putting your hand over the T-bar, grab the two vertical parts of the WS-MBI-DCU01 and squeeze
them together until all four clips are holding onto the T-bar securely and the locking tab engages.
6 Gently rock the AP to verify that it is stable and will not fall off of the T-bar.
7 Cut holes in the ceiling tile as needed, and then thread the cables through the ceiling tile if
necessary. Attach the cables and start the AP.
8 Put the ceiling tiles back in place.
ExtremeWireless™ WS-AP3825i & WS-AP3825e Installation Guide for version .
following figure:
Installation
22