Extreme Networks Extreme Wireless WSAP3825i Installation Manual page 23

WS-MBI-WALL-01 Mounting Bracket on Junction/Gang Box
The WS-MBI-WALL-01 can be mounted on a junction/gang box, wall, or a solid ceiling. When mounting
on a solid ceiling, it is required that you use a Kensington lock or an equivalent lock.
Figure 12: WS-MBI-WALL-01 Bracket
To mount the WS-MBI-WALL-01 bracket on a junction or gang box:
1 Put the center of the bracket as close as possible to the center of the box. Find two bracket holes
that line up with the box screw holes. The bracket holes that you select should be on opposite sides
of the center hole.
2 Feed the LAN cable(s) from the box going through the semi-circular center hole of the bracket.
3 Using the provided screw hardware, attach the bracket to the box using the two holes you identified
previously. Tighten the screws to a torque of 9.0 inch-lbs.
4 Attach the LAN cable(s) to the AP and push the remaining cable length(s) back into the box.
5 Align the AP3825 mounting holes onto the two mounting circles and slide it down.
6 (Required for ceiling installations) Attach a Kensington lock (or its equivalent) through the lower left
tab and into the AP.
ExtremeWireless™ WS-AP3825i & WS-AP3825e Installation Guide for version .
Installation
23