2 Drill two holes in the wall to match the center of the two keyhole slots in the back of the AP. The
location of the holes is depicted in
holes should be slightly smaller than the diameter of the provided plastic anchors.
Figure 8: Drilling Template for Wall Mounting
3 Tap the plastic anchors into the holes with a hammer until they are flush with the wall, and screw the
provided mounting screws into the anchors, with the head protruding 1/16" from the anchor.
ExtremeWireless™ WS-AP3825i & WS-AP3825e Installation Guide for version .
Figure 8
(measurements are in millimeters). For a tight fit, the
Installation
19