Troubleshooting - Hoover UH72600 Owner's Manual

If a minor problem occurs, it usually can be solved quite easily when the cause is found by using the
checklist below.
Any other servicing should be done by an authorized service representative.
If appliance is not working as it should, has been dropped, damaged, left outdoors, or dropped into
water, take it to a service center prior to continuing use.
WARNING
!
PROBLEM
Vacuum won't run 1. Power cord not firmly plugged
System Check
Indicator has
turned red
or
Vacuum won't
pick up
or
Low suction
Dust escaping
from vacuum
Headlight not
working
Vacuum is
difficult to push or
won't move
forward
Turbo Tool
brushroll won't
turn
Smoky/burning
smell detected

5. TROUBLESHOOTING

!
POSSIBLE CAUSE
into outlet.
2. Blown fuse or tripped breaker.
3. Thermal Protector activated.
1.Rinsable Filter and/ or Filter
made with HEPA media is dirty.
2. Dirt cup full and/ or clogged.
3. Broken or worn belt.
4. Brushroll and/ or Hose clogged.
5. Carpet height setting is
incorrect.
6. Suction Only Mode is ON.
7. Valve dial may be partially turned
and/or not in proper mode.
1. Dirt cup full.
2. Dirt cup not installed correctly.
3. Hose not installed correctly.
4. Rinsable and/ or Filter made
with HEPA media not installed
completely.
1. Bulb burnt out.
2. Loose electrical wires.
1. Carpet height setting is
incorrect.
2. Brushroll is activated.
1. Too much pressure being
applied to tool.
2. Blockage.
3. Low vacuum suction.
4. Valve dial may be partially turned
and/or not in proper mode.
1. Belt broken or stretched.
2. Brushroll is clogged.
To reduce the risk of personal injury -
Unplug before cleaning or servicing.
POSSIBLE SOLUTION
1. Plug unit in firmly.
2. Check fuse or breaker in home. Replace
fuse/reset breaker in home.
3. Unplug and allow vacuum to cool for
30min.(This willl reset the thermal protector)
1. Clean Rinsable Filter and or Filter made
with HEPA media - Pg. 11.
2. Empty dirt cup - Pg. 10.
3. Replace belt - Pg.14.
4. Check Hose - Pg. 13. Check Brushroll -
Pg. 12.
5. Set Carpet Height Adjustment to appropri
ate setting for carpet being cleaned - Pg.7
6. Step on Brushroll ON/OFF Pedal to turn
Suction Only Mode OFF - Pg. 6.
7. Turn valve dial to FLOOR or HOSE mode.
– Pg. 7
1. Empty dirt cup - Pg. 10.
2. Review Dirt Cup removal & replacement -
Pg. 11.
3. Review Hose installation - Pg. 8.
4. Review Filter Removal and Cleaning - Pg.
11.
1. Replace bulb - Pg. 13.
2. Call 1-800-944-9200 for nearest authorized
Hoover dealer.
®
1a. Set Carpet Height Adjustment knob to
appropriate setting for carpet being
cleaned - Pg. 7.
2. For very high pile carpet deeper than 1",
turn brushroll off.
1. Continue using tool applying light pressure.
2. Remove blockage.
3. Check items under "Vacuum won't pick up
or Low suction."
4. Turn valve dial to FLOOR or HOSE mode.
– Pg. 7
1. Replace brushroll belt - Pg. 14.
2. Clear/ remove debris from brushroll - Pg.
12.
15