Genie S-80 Operator's Manual page 31

Fifth Edition • Third Printing
Drive Enable
Light on indicates that the
boom has moved just past
either non-steer wheel and
the drive function has been
interrupted.
To drive, hold the drive enable switch to either side
and slowly move the drive control handle off center.
If the drive control handle is not moved within two
seconds of holding the drive enable switch, the
drive function will not operate. Release and hold the
drive enable switch again.
Be aware that the machine may move in the
opposite direction that the drive and steer controls
are moved.
Always use the color-coded direction arrows on the
platform controls and the drive chassis to identify
the direction the machine will travel.
Axle Indicator Light
Axle indicator light on: Extend the
axles or return the machine to the
fully stowed position.
Engine Idle Select (rpm)
Select engine idle (rpm) using the symbols on the
control panel.
When the foot switch is not pressed, the engine will
idle at the lowest rpm.
· Turtle symbol: Foot switch activated low idle
· Rabbit symbol: Foot switch activated high idle
Part No. 1000231
Platform Overload Indicator
Light (if equipped)
Machine Not Level Indicator
Light (if equipped)
Light on indicates machine is not
level. The tilt alarm will be sounding
when this light is on. Move the
machine to a firm level surface.
Check Engine Light
(if equipped)
Light on and engine stopped: Tag
the machine and remove from
service.
Light on and engine still running:
Contact service personnel within 24
hours.
S-80 • S-85
Operator's Manual
OPERATING INSTRUCTIONS
Light flashing indicates the
platform is overloaded and no
functions will operate.
Remove weight from the platform
until the light goes off.
29