Genie S-80 Operator's Manual page 24

Operator's Manual
FUNCTION TESTS
Test the Oscillating Axle (if equipped)
42 Drive the right steer tire up onto a 6 inch / 15 cm
curb or block.
Result: The three remainining tires should stay
in firm contact with the ground.
Test the Drive Enable System
43 Press down the foot switch and lower the boom
to the stowed position.
44 Rotate the turntable until the boom moves past
one of the non-steer tires.
Result: The drive enable
indicator light should
come on and remain on
while the boom is
anywhere in the range
shown.
45 Move the drive control handle off center.
Result: The drive function should not operate.
46 Move and hold the drive enable toggle switch to
either side and slowly move the drive control
handle off center.
Result: The drive function should operate.
Note: When the drive enable system is in use, the
machine may drive in the opposite direction that the
drive and steer control handle is moved.
Use the color-coded direction
arrows on the platform
controls and the drive
chassis to identify the
direction of travel.
22
Test Limited Drive Speed
47 Press down the foot switch.
48 Raise the boom to just above horizontal.
49 Slowly move the drive control handle to the full
50 Lower the boom to the stowed position.
51 Extend the boom 1 foot / 30 cm.
52 Slowly move the drive control handle to the full
If the drive speed with the boom raised or extended
exceeds 1 foot / 30 cm per second, immediately
tag and remove the machine from service.
Blue
Yellow
S-80 • S-85
Fifth Edition • Third Printing
drive position.
Result: The maximum achievable drive speed
with the boom raised should not exceed
1 foot / 30 cm per second.
drive position.
Result: The maximum achievable drive speed
with the boom extended should not exceed
1 foot / 30 cm per second.
Part No. 1000231