Display Panel; Opening The Display Panel; Using The System As A Tablet - Fujitsu LifeBook T3010 Manual

Display Panel

Your LifeBook T Series Tablet PC contains a
display panel that is backlit for easier viewing in
bright environ-ments. The convertible design of
your Tablet PC allows you to open the display
fully, rotate it 180 degrees, and lay it face up on
the keyboard. This allows you to use the system
as a tablet, much as you would use a pad of
paper.

Opening the Display Panel

1. Slide the Display Panel latch. This releases the
locking mechanism and raises the display
slightly.
2. Lift the display backwards, being careful not
to touch the screen, until it is at a comfortable
viewing angle. (Figure 2-11)

Using the System as a Tablet

If you would like to use the system as a tablet,
perform the following steps.
Rotate the system display only in the
direction indicated in the procedure.
Turning the display in the incorrect
direction could cause hinge damage.
In the following step, be sure to position
the display perpendicular to the keyboard,
otherwise the keyboard or display cover
could get scratched.
1. Lift the display until it is perpendicular to the
keyboard. (Figure 2-12)
Figure 2-11. Opening the display
2. When the display is perpendicular to the
keyboard, rotate it clockwise (when viewed
from the top). Be very careful to rotate it in the
correct direction. (Figure 2-13) . Turn the display
180 degrees so that it is facing backwards.
(Figure 2-14)
3. Holding the top edge of the display panel, pull
it forward until it is lying flush with the top of
the keyboard and latches into place. You can
now use your system as a tablet.
(Figure 2-15)
4. To return the system to notebook
configuration, repeat step 3 and 2. Be sure to
turn the display in the opposite direction when
performing step 2.
G e t t i n g t o K n o w Yo u r Tablet PC
Display Panel Latch
Figure 2-12. Fully open display
Figure 2-13. Rotating the display
15