Fujitsu LifeBook T3010 Manual page 88

5. Right-click [Wireless Network Connection] in
the list, and then click [Properties] in the menu
displayed. The [Wireless Network Connection
Properties] window will be displayed.
6. Click the [Wireless Networks] tab.
7. Click [Refresh], then choose the correct SSID
from the [Available Networks] window. Click
[Configure] and proceed to step 7. If the SSID
of your access point does not appear in the
list, click [Add]. The [Wireless Network
Properties] window will be displayed.
8. Select the Association tab if it is not already
selected.
9. Enter the information required for connection
to the wireless LAN.
a. Enter the network name (SSID). (i.e., Enter
the name of the desired network in less than
33 ASCII characters).
For ad hoc connection: Assign the same
network name to all the personal computers
to be connected.
For infrastructure connection: Assign the
appropriate SSID. The SSID must be
identical to the SSID of the access point.
Refer to the access point manual, or contact
your network administrator.
b. For ad hoc connection, check the
following field.
For infrastructure connection, clear the
check mark for the following field:
[This is a computer-to-computer (ad hoc)
network; wireless access points are not
used.]
10. Enter the WEP
communications data.
It is strongly recommended that you enter
the network key
communications data. If the network key is
not entered, since the network can be
accessed from all personal computers
containing the wireless LAN function, there
is the danger of your data being stolen or
damaged by other users.
76
key for encoding
for encoding
In infrastructure mode, WEP must be enabled
on the access point in order for WEP to work.
The WEP key entered on the client must be
identical to the WEP key entered in the
access point. In ad hoc mode, the WEP key
must be entered identically on each
computer.
a. Check the [Data encryption (WEP enabled)]
check box
For ad hoc connection: Clear the check
mark from the [Network Authentication
(Shared mode)] check box.
For infrastructure connection: If the
access point to be accessed has acquired
shared-key authentication, check the
[Network Authentication (Shared mode)]
check box.
For open-system authentication, clear the
check mark. For access point setting, refer
to the manual of the access point.
b. Clear the check mark from the [The key is
provided for me automatically] check box.
c. Enter data in [Network Key]. Depending on
the number of entered characters or digits,
whether the key is an ASCII character code
or a hexadecimal code will be identified
automatically.
• Use five or thirteen characters to enter
the key in the ASCII character code
format. The characters that can be used
as the "network key" are as follows: 0 - 9,
A - Z, _ (underscore), or,
• Use 10 or 26 characters to enter the key
in the hexadecimal character code
format. The characters that can be used
as the "network key" in this case are as
follows: 0- 9, A - Z, a - f
For ad hoc connection: Assign the same
network key to all the personal computers
to be connected.
For infrastructure connection: Assign
the identical network key that is
programmed into the access point. For
this setting, refer to the access point
manual or contact your network
administrator.