Connection To The Network - Fujitsu LifeBook T3010 Manual

d. Confirm the Network key by re-entering the
same data in the [Confirm network key:]
field.
e. Make sure that [Key index (advanced)] is
set to "1". (Any value from "1" to "4" can be
assigned to [Key index (advanced)]. "1" is
usually assigned, however).
11. Click the [Authentication] tab and then verify
the settings of [Enable network access
control using IEEE 802.11x].
For internal use at an organization such as a
company, when access by wireless LAN
clients is to be limited using IEEE 802.11x
authentication, check the [Enable network
access control using IEEE 802.11x] check
box.
For home use, clear the check mark from
[Enable network access control using IEEE
802.11x].
For the setting method relating to IEEE
802.11x authentication, refer to the manual
of the access point which you are using.
12. After completion of setting operations, click
the [OK] button. Processing will return to the
[Wireless Network Connection Properties]
window.
13. Verify that the network name entered in step
7 above is added in [Preferred Networks], and
then click the [OK] button.
In [Preferred Networks], register only the
desired connection settings.
14. Close the [Wireless Network ] window.

Connection to the Network

This section explains connection to the network.
If there is an administrator of the network, contact
the network administrator for data settings.
Setting the network
Perform the "Setting TCP/IP" and "Confirming the
computer and work group names" operations
required for network connection.
Wireless LAN User's Guide
Setting TCP/IP
To change the setting of the IP address, you
need to be logged in from Windows as an
administrator.
1. Click the [Start] button first and then [Control
Panel].
2. If the Control Panel is in Category view, switch
to Classic view by clicking "Switch to Classic
View" under Control Panel the left frame. (If
you are already in Classic view, "Switch to
Category View" will be displayed.)
3. Double-click [Network Connections]. A list of
currently installed networks will be displayed.
4. Right-click [Wireless Network Connection] in
the list, and then click [Properties] in the menu
displayed. The [Wireless Network Connection
Properties] window will be displayed.
5. Click the [General] tab if it is not already
selected.
6. Click [Internet Protocol (TCP/IP] and then
click [Properties]. The[Internet Protocol (TCP/
IP) Properties] window will be displayed.
7. Set the IP address as follows:
• For ad hoc connection: Select [Use the
following IP address:] and then enter data
for [IP address] and [Subnet mask].
• For infrastructure connection: If your
network uses DHCP, select [Obtain an IP
address automatically] and [Obtain DNS
server address automatically]. If your
network uses static IP addresses, consult
with your network administrator for the
correct IP address settings.
8. Click the [OK] button. Processing will return
to the [Wireless Network Connection
Properties] window.
9. Click the [OK] button.
10. Close the [Network Connection] window.
Following this operation, confirm the names of
the computer and the workgroup as follows.
77