Pre-installation and application warnings
Firmware notes: This section highlights important information for this specific firmware and will assist in
pricing accordingly, as well as bringing awareness to any operational or vehicle limitations.
T-Harness
compatible
Unless specified otherwise, all connectors are displayed from the wire side, with the exception of the OBDII diagnostic
connector.
Important!
This firmware does NOT support Immobilizer bypass. One (1) programmed OEM key must be wired into the
vehicle to complete the installation of a remote starter.
Refer to "Vehicle connections" following the wiring diagram.
General notes: This section highlights important information for this specific firmware.
Tach wire is an optional connection required on some remote starters, which do not support a tach signal in D2D.
[1]
For Key Wrap instructions, refer to "Immobilizer interface with OEM immobilizer receiver".
[2]
All information listed for the 2017 Golf R (Smart Key) is for automatic transmissions ONLY.
[3]
5
Keys required for
1
Keys required for
programming
operation
403.VW06 1.41 2017 Volkswagen Golf GTI (Smart Key)
© 2017-10-25 Directed. All rights reserved.
1