Download Print this page

Malaguti F18 Electric System Troubleshooting page 56

Hide thumbs Also See for F18:

Advertisement

F18 - 125
F18 - 125
cc / 150cc
cc / 150cc
F18 - 125cc / 150cc
F18 - 125
F18 - 125
cc / 150cc
cc / 150cc
TRAFFIC BEAM PILOT LIGHT
TRAFFIC BEAM PILOT LIGHT
TRAFFIC BEAM PILOT LIGHT
TRAFFIC BEAM PILOT LIGHT
TRAFFIC BEAM PILOT LIGHT
- Tester terminal (+): white/blue
white/blue cable terminal
white/blue
white/blue
white/blue
black
black
- Tester terminal (-): black
black
black cable terminal
• Change-over switch key on "ON"
• Position the light change-over switch on (
• Position the left change-over switch on traffic beam (
- Voltage must be 12 Volts.
12 Volts.
12 Volts.
12 Volts.
12 Volts.
- Out of specification: the circuit between the four-way connector, which is fitted into the dashboard, and the left
change-over switch connector is defective. Locate the break between white/light blue
- According to the specification: the circuit is efficient. Check the lamp holder and the dashboard printed circuit. If
necessary, replace (F. 37).
LAMPE TEMOIN CODES
LAMPE TEMOIN CODES
LAMPE TEMOIN CODES
LAMPE TEMOIN CODES
LAMPE TEMOIN CODES
- Borne (+) testeur : cosse câble blanc/bleu
- Borne (-) testeur : cosse câble noir
• Clef démarreur sur "ON"
• Mettre le commutateur feux sur (
• Mettre le commutateur gauche sur codes (
- La tension doit être de 12 volts.
- Non conforme aux indications : le circuit entre le connecteur à quatre voies introduit dans le tableau de bord, et le
connecteur du commutateur gauche est défectueux. Trouver l'interruption du câble blanc/bleu clair
- Conforme aux indications : le circuit est en état de marche, contrôler la douille et la piste de circuit imprimé du
tableau de bord ; si besoin est, changer (F. 37).
LUZ INDICADORA ANTIDESLUMBRANTE
LUZ INDICADORA ANTIDESLUMBRANTE
LUZ INDICADORA ANTIDESLUMBRANTE
LUZ INDICADORA ANTIDESLUMBRANTE
LUZ INDICADORA ANTIDESLUMBRANTE
- Terminal (+) tester: terminal cable blanco/azul
- Terminal (-) tester: terminal cable negro
• Llave conmutador en "ON"
• Situar el conmutador luces en (
• Situar el conmutador izquierdo en antideslumbrante (
- La tensión debe ser de 12 volt.
- Fuera del valor especificado: el circuito entre el conector de cuatro vías conectado en el salpicadero, y el conector
del conmutador izquierdo es defectuoso. Inidviduar la interrupción del cable blanco/azul
- Como el valor especificado: el circuito funciona, controlar el portalámpara y el salpicadero, si es necesario, sustituir
(F. 37).
)
blanc/bleu
blanc/bleu
blanc/bleu
blanc/bleu
noir
noir
noir
noir
)
):
12 volts.
12 volts.
12 volts.
12 volts.
blanco/azul
blanco/azul
blanco/azul
blanco/azul
negro
negro
negro
negro
)
12 volt.
12 volt.
12 volt.
12 volt.
):
white/light blue cable and repair.
white/light blue
white/light blue
white/light blue
):
55
11/00
blanc/bleu clair
blanc/bleu clair et réparer.
blanc/bleu clair
blanc/bleu clair
blanco/azul
blanco/azul
blanco/azul y reparar.
blanco/azul

Advertisement

loading